
You save $2,100.00 at Audio Intensity
Deal.ai's agents found this deal on November 22. The store may have changed its price since.
In stock
Crescendo Revolution Speaker Series
Crescendo Revolution 7S3 3-Way Speaker System
The reference-grade step up from the 5S3. Treated paper cones with integrated dust caps on the midbass and midrange, a larger stainless steel tweeter housing, neodymium motors on all high-frequency drivers, and a heavier midbass assembly at 1625 grams. Same active-only architecture: three drivers, six amplifier channels, DSP required.
3-Way Active
DSP Required
6 Amp Channels
Reference Series
7S3 vs 5S3: What Changes at the Reference Level
The Crescendo Revolution 5S3 and 7S3 share the same 3-way active architecture, the same 6.5 inch midbass and 4 inch midrange dimensions, the same frequency ranges per driver, and the same 4-ohm impedance throughout. The 7S3 is not simply a more expensive version of the same product. The cone materials, chassis construction, and tweeter design change meaningfully at the reference level.
The 5S3 uses fiberglass cones with separate fiberglass dust caps on both the midbass and midrange. The 7S3 uses treated paper cones with dust caps integrated into the membrane on both drivers. The 5S3 tweeter is 28mm dome in an aluminum housing. The 7S3 uses a stainless steel housing with a larger dome assembly and neodymium motor. The 5S3 midbass weighs 1358 grams. The 7S3 midbass weighs 1625 grams without the front ring, 1895 grams with it. That additional mass reflects a heavier motor, more robust chassis, or both.
System requirements: The Revolution 7S3 requires a minimum of 6 amplifier channels and an active DSP processor or active electronic crossover. There is no passive crossover included. If your installation does not include DSP-controlled active processing, this is not the correct product.
1625gMidbass Weight
3-WayActive Design
6 ChAmp Channels
50-100WRMS Per Driver
Three Drivers at Reference Grade
Midbass
6.5 in
Treated paper cone with integrated dust cap, 134mm moving diameter, cast aluminum chassis, ferrite overhung motor. 50-100W RMS, 4 Ohm, 55 Hz-4.5 kHz. Heavier assembly than the 5S3 at 1625g (1895g with front ring).
Midrange
4 in
Treated paper cone with integrated dust cap, 61mm moving diameter, cast aluminum chassis, neodymium motor. 50-75W RMS, 4 Ohm, 160 Hz-12 kHz. Neodymium motor versus the 5S3 midrange, lower power limit at 75W max.
Tweeter
24mm
The Revolution 7S3 is Crescendo's reference 3-way active component set: a pair each of 6.5-inch midbass drivers, 4-inch midranges and 24mm fabric dome tweeters, with no passive crossover in the box. It needs a DSP and at least six amplifier channels, so it is a build for people who tune their own system rather than a drop-in swap. Against the 5S3 it shares the same driver sizes, impedance and frequency ranges, but moves to treated paper cones with integrated dust caps, a heavier 1625-gram midbass and a larger neodymium tweeter in a stainless steel housing. That makes it the pick for listeners chasing detail and dynamics who already own the processing to control it.
It checks today's price at every store, compares the alternatives and answers in about a minute.