What does 1.5HP and 295 ft lift mean in practice?

The pump can raise water up to about 295 ft of vertical head. Flow drops as lift rises, so the 24 GPM figure applies near the low-lift end, not at full height.

It needs a well casing wider than 4 inches (10.16 cm). The pump body is about 3.8 inches across, so a standard 4-inch well leaves little clearance.

What else do I need to install it?

You need drop pipe, a torque arrestor, a pressure tank, a pressure switch and wiring to the built-in control box. The pump ships with the outlet, control box, cable and manual only.

Can it run on a standard 110V outlet?

It is rated 110V/60Hz with a US plug, but a 1.5HP motor draws high current on startup. A dedicated circuit sized for the motor is safer than a shared household outlet.

Does it include a check valve?

Yes, a built-in check valve prevents water from draining back and the impellers from spinning backward. A second check valve on the drop pipe is still common practice.

Is it good for a shallow well?

It works, but a shallow-well jet pump is usually simpler and cheaper for short lifts. This pump is built for deep settings where high lift matters.

Unbranded

1.5HP Deep Well Water Pump Submersible Stainless Steel 295ft 24GPM 110V

Best price now

$221.00at WalmartChecked Nov 9

Prices are checked against each store and labelled with when.

Visit Walmart

Unbranded

1.5HP Deep Well Water Pump Submersible Stainless Steel 295ft 24GPM 110V

Best price now

$221.00at WalmartChecked Nov 9

Prices are checked against each store and labelled with when.

Visit Walmart

Ask our agent about this product

It checks today's price at every store, compares the alternatives and answers in about a minute.

Price facts

Last seen at $221.00 at Walmart on Nov 9.

Our take on the 1.5HP Deep Well Water Pump Submersible Stainless Steel 295ft 24GPM 110V

This is a 1.5HP stainless steel submersible well pump rated for wells at least 4 inches wide. It lists a 295 ft maximum lift and 24 GPM maximum flow, with nine thermoplastic impellers, a built-in check valve and a 33 ft power cable. It suits deep wells and pressure-tank setups where a pump must push water far and high. It is a bare pump with no tank, pressure switch or controller beyond the built-in control box, so it competes on lift and flow rather than on extras.

Best forDeep wells with a 4-inch or wider casingPumping to a pressure tank or storage cisternOff-grid or rural water supply on 110V

Pros

High 295 ft maximum lift for its class
24 GPM maximum flow with nine impellers
Stainless steel body resists corrosion
Built-in check valve stops backflow and impeller backspin
Rated under 65 dB
33 ft cable included

Cons

No pressure tank, switch or external controller included
Requires a well at least 4 inches in diameter
Heavy at about 35 lbs, awkward to install alone
Unbranded, so parts and support are harder to source
No stated warranty or certification details

1.5HP Deep Well Water Pump Submersible Stainless Steel 295ft 24GPM 110V prices at every store

WalmartNew
In stockSold by DENCREST HomeReturns: Sold by a Walmart Marketplace seller; returns go to the seller under the seller's returns policy.
$221.00Free shippingChecked Nov 9
Visit Walmart

About the 1.5HP Deep Well Water Pump Submersible Stainless Steel 295ft 24GPM 110V

This is a 1.5 HP (1.1 kW) electric submersible deep well pump. The body is made of stainless steel, and it has nine impellers. It runs on 110V/60Hz power and has a US plug.

Once installed, the pump is lowered into the water to pump. It lifts water up to 295 ft (90 m) at a maximum flow of 24 GPM (5.6 m³/h). A built-in check valve allows vertical installation and keeps water from flowing back and spinning the impellers backward. The thermoplastic impellers are designed for high flow and high lift, and a stainless steel filter screens out impurities. For newly drilled wells with a lot of granular sediment, a layer of gauze can be added before the filter inlet.

It suits wells with a diameter over 4 inches, and can also lift water from rivers, reservoirs and canals. Uses include farmland irrigation, water for people and animals, and drainage. Pumping speed drops as the water intake gets deeper. The pump must not run without water. If it is used in a pressure system, at least one external check valve is needed in the pipeline. Do not touch the pump while it is working, and do not lift or pull it by the cable. Cut the power before maintaining, moving or cleaning it.

Model: 3SDM3/9
Color: Silver
Style: Submersible
Material: Stainless steel
Power source: Electric
Power: 1.5 HP / 1.1 kW
Voltage: 110V, 60Hz
Plug type: US plug
Max. lift: 90 m / 295 ft
Max. flow rate: 5.6 m³/h / 24 GPM
Max. speed: 3420 r/min
Impellers: 9
Noise: Under 65 dB
Well diameter: Over 10.16 cm / 4 in
Outlet: 3.18 cm / 1.25 in
Pipe OD: 9.8 cm / 3.8 in
Cable: Flat blue cable, 10 m / 33 ft
Product height: 81 cm / 32 in
Package size: 111 x 12 x 20 cm / 43.7 x 4.72 x 7.87 in
Gross weight: 16.95 kg / 37.37 lbs
Net weight: 15.95 kg / 35.16 lbs
In the box: 1 submersible well pump, 1 built-in control box, 1 outlet, 1 English manual

Specifications

color: SilverSource

Questions and answers

What does 1.5HP and 295 ft lift mean in practice?: The pump can raise water up to about 295 ft of vertical head. Flow drops as lift rises, so the 24 GPM figure applies near the low-lift end, not at full height.
Will it fit my well?: It needs a well casing wider than 4 inches (10.16 cm). The pump body is about 3.8 inches across, so a standard 4-inch well leaves little clearance.
What else do I need to install it?: You need drop pipe, a torque arrestor, a pressure tank, a pressure switch and wiring to the built-in control box. The pump ships with the outlet, control box, cable and manual only.
Can it run on a standard 110V outlet?: It is rated 110V/60Hz with a US plug, but a 1.5HP motor draws high current on startup. A dedicated circuit sized for the motor is safer than a shared household outlet.
Does it include a check valve?: Yes, a built-in check valve prevents water from draining back and the impellers from spinning backward. A second check valve on the drop pipe is still common practice.
Is it good for a shallow well?: It works, but a shallow-well jet pump is usually simpler and cheaper for short lifts. This pump is built for deep settings where high lift matters.
Where is the 1.5HP Deep Well Water Pump Submersible Stainless Steel 295ft 24GPM 110V cheapest?: At Walmart, for $221.00, as of our latest check.