Prices are checked against each store and labelled with when.
This is a 10-pack of pre-slit, closed-cell neoprene foam pipe sleeves with a self-adhesive aluminum foil wrap. Each tube is 1.31 ft long with a 3/4-inch bore, so the set covers roughly 13 feet of pipe. The foil facing reflects radiant heat, sheds water and blocks UV, which suits outdoor spigots, risers and exposed lines. The pre-slit seam and peel-and-stick strip mean one person can wrap a pipe without tape or glue. It is a light-duty freeze and condensation wrap, not a substitute for heat tape or a full pipe-insulation system.
In stockSold by GimetoeReturns: Sold by a Walmart Marketplace seller; returns go to the seller under the seller's returns policy.
This is a 10-pack of pre-slit foam tubes for wrapping pipes. Each tube is 1.31 ft (15.7 in) long with a 3/4 in inner diameter and a 0.39 in wall thickness, for 13.1 ft of total coverage.
The tubes are made of closed-cell neoprene rubber foam with a fiberglass-reinforced aluminum foil exterior. The foam traps air in small pockets to form a thermal barrier, and the foil reflects radiant heat back toward the pipe, sheds water and snow, and blocks UV rays. The foam is self-extinguishing and meets basic flame-retardant standards for residential use.
To install, open the pre-slit seam along the tube and snap it around the pipe. Peel the self-adhesive strip on the foil, then press and seal; no tape or glue is needed. Where two tubes meet, overlap them by 1 inch. The insulation can be used on both hot and cold pipes, and on outdoor spigots and hose bibs, sprinkler risers, water heater lines, exterior wall plumbing, air conditioner condensate lines, solar water heater tubing, RV and camper water lines, and exposed basement and crawl space pipes.
It checks today's price at every store, compares the alternatives and answers in about a minute.



