
1000W Electric Single Burner Portable Coil Heating Hot Plate Stove Countertop RV Hotplate with Non Slip Rubber Feet 5 Temperature Adjustments
Best price now
Prices are checked against each store and labelled with when.

Prices are checked against each store and labelled with when.
A single 1000W coil burner on a compact countertop body, with five heat settings from about 302°F to 1022°F and a thermostat that cycles the element to hold the set level. It is built for small kitchens, dorms, RVs, camping with an outlet, and extra cooking surface on busy days. Against induction and glass-top single burners it is cheaper in build and works with any flat-bottomed pot, but the exposed coil heats slowly, stays hot after shutoff, and gives coarser control than a gas flame or induction plate.
In stockShips from Canada · duties may applyReturn policy
Owners treat it as a cheap, compact backup burner that does simple jobs well. Many note the coil is slow to heat and the low settings are still fairly hot, and some find the build light and the surface hard to clean around the coil.
This is a single electric coil burner with a 6 in (about 14 cm) heating element and 1000W of power. It measures about 8.07 x 9.25 x 2.37 in with the feet attached and weighs 613 g (1.35 lbs), so it can be carried and stored easily. The body is made of powder-coated iron sheet with a 201 stainless steel heating tube and copper-clad aluminum wire.
Five temperature gears run from 302°F to 1022°F, within ±20°C: 302°F, 500°F, 698°F, 842°F and 1022°F. An indicator light on the front of the enclosure goes out when the plate reaches the set temperature and comes back on when it drops below it, cycling to hold the heat. Non-slip rubber feet keep the unit in place on a counter.
The burner takes any flat-bottomed cookware — frying pans, woks or stovetop teapots in aluminum, stainless steel, iron or glass — with a smooth base that matches the size of the plate; a ceramic pot may heat very slowly. Let it cool completely and unplug it before wiping the non-electrical parts with a damp sponge or half-wet cloth. On first use, run it on the third gear for 3 to 5 minutes to evaporate the protective film on the surface; a small amount of smoke is normal and does not happen again.
It checks today's price at every store, compares the alternatives and answers in about a minute.



