

This is a single threadless flat back earring: a 2.7mm round bezel-set lab-grown diamond (0.03 ctw) in 14K yellow gold, on an ASTM F136 titanium post. The bezel setting sits low and snag-free, and the flat back is comfortable for sleeping and everyday wear. It suits cartilage, helix, lobe and other piercings where a small, secure stud matters. Against prong-set diamond studs it trades sparkle for durability and a lower profile; against plain titanium studs it adds a gold-and-diamond look while keeping the hypoallergenic post.
In stockReturn policy
Rated 4.5 out of 5 from 14 ratings. Buyers like the low-profile bezel and the comfortable flat back for cartilage piercings, though some note the stone is tiny and the threadless fit takes getting used to.
This is a flat back stud with a bezel-set lab-grown diamond in 14K yellow gold. It is sold as a single earring. The post is ASTM F136 titanium, the grade used for piercing.
The stud is threadless, so tension holds it in place and nothing twists or screws on. To wear it, insert the post from the back of the ear. Slide the slightly bent front pin into the post and press firmly to close. Tug lightly from both ends to check that it is secure. To remove it, twist and pull.
You won't hear a click when it closes. It should feel snug and secure. If the pin feels loose, take the post out of your ear and use it as a bending tool. Put the pin halfway into the post and bend it slightly to increase tension. Then push the front all the way into the post and remove it to check the tension.