This is a 100-amp, 600V aluminum service entrance cable built to run power from a meter base to the main panel in a mobile or manufactured home. It also works as a feeder to subpanels in garages, sheds, modular buildings and other outbuildings. Its cross-linked polyethylene insulation resists moisture, abrasion and chemicals, and it is approved for direct burial when marked USE-2, or for conduit, ducts and raceways in wet or dry locations. Buyers rate it highly; the main trade-offs are aluminum conductors, which need antioxidant and aluminum-rated lugs at terminations, and the need to confirm the USE-2 marking before burying it.
In stockReturn policy
Buyers rate this cable 5 out of 5 across 65 ratings, with no complaints recorded. The feedback centers on it doing the job it is sold for as a mobile home feeder.
This is a 2-2-4-6 aluminum mobile home feeder cable rated for 100 amps and 600 volts. It is a service entrance cable that carries power from a utility meter base to the main panel in a mobile or manufactured home. It is also used as a feeder to subpanels in modular buildings, small homes, sheds, garages and other outbuildings.
The cable has two 2 AWG phase conductors, one 4 AWG neutral and one 6 AWG ground. All are compact stranded 8000 series aluminum. The insulation is cross-linked polyethylene (XLP), which resists impact, abrasion, moisture, chemicals, acids, oils, industrial solvents and weather changes. The conductors are normally cabled together with an XLP insulated aluminum ground or a bare copper ground, covered with reinforced binder tape.
When marked USE-2, the cable is approved for direct burial. It can also be installed in conduit, ducts or raceways in wet or dry locations. At this size it is commonly used to deliver 100 amps to secondary panels for lighting, outlets, appliances or HVAC systems.