This rear-wheel conversion kit turns a standard bicycle into an electric bike. It is built around a 2000W brushless, gearless direct-drive hub motor laced into an MTX alloy rim. The controller works with 48V, 52V, 60V or 72V batteries. The battery and charger are not included. The battery must supply a minimum continuous current of 45 amps.
The kit fits bikes with a 135 mm rear drop-out width and screw-on freewheels. It works with hydraulic or mechanical disc brakes. It does not fit rear thru-axles, V-brakes or cassette hubs. For full-power use, torque arms on both sides of the bike are recommended to keep the axle from spinning in the dropouts.
The kit is intended for off-road use only, so check local laws before buying. In restricted mode it is limited to 250W continuous and 25 km/hr. To start, press the M button on the LCD display. Keep it out of water and heavy rain. It is best suited to paved surfaces and light gravel tracks, not jumps, curb impacts, wheelies or downhill riding.
- Wheel type
- Rear wheel
- Wheel sizes
- 26", 27.5" or 29" (29er / 700C)
- Motor
- Brushless DC direct drive (gearless) rear hub motor
- Power
- 2000W, or 250W continuous in restricted mode
- Torque
- 75 Nm
- Top speed
- 75 km/hr with a 72V battery; 25 km/hr in restricted mode
- Controller
- 45A pure sine wave brushless controller
- Battery voltage
- 48V, 52V, 60V or 72V
- Battery requirement
- Minimum 45 A continuous current
- Battery connector
- XT60 (may differ from photo)
- Display
- LCD SW900 (or UKC1)
- Rim
- MTX alloy, double wall, 33 mm internal width
- Spokes
- Steel, 12G x 2.6 mm
- Tire fit
- Rim best suited to 2.125" to 2.5" wide tires
- Drop-out width
- 135 mm (not for thru-axles)
- Axle
- 210 mm x 10 mm diameter; 21 mm axle nuts
- Gear type
- Freewheel / screw-on (not for cassette)
- Brake compatibility
- Hydraulic or mechanical disc brakes (not V-brakes)
- Weight
- 10 kg
- Load capacity
- 150 kg, including the completed bike and rider
- In the box
- 2000W rear hub motor wheel; 45A pure sine wave controller; LCD SW900 display (or UKC1); pedal assist crank sensor (PAS); full-twist right-hand throttle with matching left-hand grip; cable tie set; pai
- Not included
- Battery, battery charger, torque arms, tools, freewheel gear, instructions, disc brakes