
3D Printer Pen 3D Drawing Pen 3D Printing Toy W/ 6 Random Colors Filaments
Best price now
Prices are checked against each store and labelled with when.

Prices are checked against each store and labelled with when.
It checks today's price at every store, compares the alternatives and answers in about a minute.
A handheld 3D printing pen that melts 1.75 mm PLA filament and extrudes it so you can draw freehand shapes in the air or on paper. It heats to 160–230°C, has adjustable extrusion speed, and runs from a 5V 2A adapter or a power bank. It is a low-cost starter tool for kids and beginners trying 3D drawing, and it sits below branded pens on control and safety features. Expect a plastic body, a single temperature band, and no display or filament sensor.
In stockSold by Fuller International Corp.Returns: Sold by a Walmart Marketplace seller; returns go to the seller under the seller's returns policy.
This 3D printing pen draws in three dimensions by melting plastic filament and extruding it through a heated tip. It uses fused deposition modeling, and the drawing area is unlimited. The extrusion speed is adjustable, and the heating temperature ranges from 160 to 230 degrees Celsius.
To use it, connect the pen to power or to a power bank. Press button 1 to turn it on and start heating. The light is red while the tip heats. Button 2 selects ABS or PLA mode. When the light turns blue, insert the filament. A short press on button 3 starts continuous printing, and pressing it again pauses. A long press starts manual printing. Buttons 4 and 5 raise and lower the speed.
To remove the filament, long press button 1. Press button 1 again to power off. The pen also unloads the filament after 30 minutes of no use.




