It checks today's price at every store, compares the alternatives and answers in about a minute.
This is a round dual run capacitor rated 40+5 MFD at 370 or 440 VAC, the part that starts and runs the compressor and condenser fan in most residential AC and heat pump units. It uses a three-terminal C/HERM/FAN layout, a +/-5% tolerance and a sealed aluminum case rated for 10,000 AFC fault current. It cross-references common OEM numbers such as USA2235, TRCFD405, P291-4054RS and C3405R, so it drops into many systems without a brand-specific part. Buyers rate it highly; the main risks are ordering the wrong microfarad rating or a case that does not fit the mounting bracket.
In stockShips from Hong Kong SAR China · duties may applyReturn policy
Owners rate it 4.8 out of 5 and mostly report it as a direct drop-in replacement that gets AC units and heat pumps running again. Complaints center on fitment and on receiving a unit that failed early.
This is a round dual run capacitor with two capacitance sections, 40 and 5 microfarad (MFD), rated for 370V or 440V AC. It is used in air conditioner condensers, heat pumps and other HVAC systems, and serves as a universal replacement for round dual run capacitors with matching 40/5 MFD capacitance and 370V or 440V ratings.
The capacitor has a round aluminum case and a three-terminal configuration marked C, HERM and FAN. Tolerance is +/- 5% at 50/60 Hz, and the operating temperature range is -40°C to +70°C (-40°F to +158°F). It carries a 10,000 AFC fault current protection rating. The case measures approximately 2.0 - 2.4 inches in diameter and 3.7 - 5.25 inches in height, so fitment should be verified before purchase.
A 440V capacitor can replace a 370V capacitor, but a 440V capacitor should not be replaced with a 370V unit. Before servicing, disconnect all electrical power to the HVAC unit and discharge the existing capacitor by shorting across its terminals with an insulated-handle screwdriver. Note or photograph the wire placement on the C, HERM and FAN terminals, connect the wires to the corresponding terminals on the new capacitor, and secure it with the original mounting bracket to prevent vibration.