It checks today's price at every store, compares the alternatives and answers in about a minute.
The 52Pi M.2 NVMe 2280 PoE+ HAT is a Raspberry Pi 5 expansion board that adds both an M.2 NVMe SSD slot and Power over Ethernet in one stack. It accepts M-key drives in 2230, 2242, 2260 and 2280 lengths and draws 802.3at PoE+ input up to 25.5W, delivering 5.1V at up to 4.5A to the Pi and its peripherals. That makes it a fit for headless builds, clusters and wall- or ceiling-mounted nodes where one Ethernet cable carries data and power. Against separate PoE and NVMe HATs, it saves a stacking layer and a power supply, but it commits you to a PoE+ switch or injector and leaves less room for other HATs.
In stockShips from the UK · priced in GBP (£22.42) · duties may applyReturn policy
Owners rate it well overall, with the combined PoE and NVMe layout the main draw. Complaints center on the PoE+ requirement and the power ceiling.
The 52Pi M.2 NVMe 2280 PoE+ HAT is an expansion board for the Raspberry Pi 5 that adds both M.2 NVMe SSD storage and Power over Ethernet. With a PoE+ switch or injector, it powers the Raspberry Pi 5 directly over the Ethernet cable, so no separate power supply is needed and cabling stays simple.
The board has an M.2 NVMe M-key interface and takes SSDs in 2230, 2242, 2260 and 2280 sizes. Power comes in over 802.3at (PoE+) at up to 25.5W, and the board outputs 5.1V at up to 4.5A to the Raspberry Pi 5 and any attached peripherals. A power status indicator on the board shows its state.
It fits inside the 52Pi ZP-0164 Tall Aluminium Cooling Case with the fan removed, and it supports the official Raspberry Pi 5 Active Cooler. Do not connect the USB-C port to another power source while the HAT is in use, as this can damage the board. The Raspberry Pi, SSD and Active Cooler are not included.