The Active 3.0 is an electric pressure washer for car detailing. It has a patented 5-piston pump that produces 3.0 gpm and 1000 psi at 18 amps. The high flow is meant to make rinsing faster and to help move contamination off the surface.
A low-speed induction motor rated for 1600 rpm brings operating noise down to about 75 dB. An oil plug and drain make maintenance easier, and the unit has upgraded seals, valves and pistons.
Through a foam cannon, the higher flow produces foam that is thinner and more fluid than the foam from lower-GPM consumer units. This foam spreads evenly over the vehicle and stays on the surface for dwell time before rinsing.
- Flow rate
- 3.0 gpm
- Pressure
- 1000 psi
- Pump
- Patented 5-piston pump
- Motor
- Low-speed induction motor, rated 1600 rpm
- Noise level
- Approximately 75 dB
- Power
- 18 amps, 120V/60Hz
- Circuit required
- 20 amp circuit with 20 amp breaker and outlet
- Plug
- NEMA 5-20R plug (horizontal "T" on the neutral side)
- Extension cord
- Not recommended; if needed, no longer than 50 feet and rated 12 AWG
- Maintenance
- Oil plug and drain; upgraded seals, valves and pistons