Audiofrog GB10OE-0011 1 in. GB10 Tweeters
Best price now
Compared across 3 stores. Prices are checked against each store and labelled with when.
Compared across 3 stores. Prices are checked against each store and labelled with when.
The Audiofrog GB10 is a pair of 1-inch car tweeters built for serious component systems. They use a polyester diaphragm in a cast zinc housing, handle 20–100 watts RMS (300 W peak), and reach up to 24 kHz with a 4-ohm, 90 dB load. A copper pole-piece cap cuts distortion, and the flush-mount kit lets them sit behind a factory panel or in a custom spot. They suit owners chasing clean, detailed highs from an amp-driven system; they need a crossover and an amplifier, since they are tweeters only, not a full-range set.
In stock
In stock
Out of stock
Lowest price we've seen: $469.00 on Nov 22 at Abt Electronics & Appliances. Tracked across 2 stores since Nov 22.
The GB10 is a 1 in. car tweeter, sold as a pair. Each one is built around a polyester diaphragm in a cast zinc housing with a chrome-plated finish, and the housing can be painted to match an installation.
Power handling is 20 to 100 watts RMS, with a recommended amplifier power in that range and a 300 watt maximum, at 4 ohm impedance and 90 dB sensitivity. Frequency response runs from 1800 to 24000 Hz, and a pole piece cap is used to reduce distortion.
The tweeters mount flush behind the panel in factory or custom locations, using screw terminals for wiring and the included mounting kit. The design is weather-resistant rather than waterproof, and it is intended for a sealed enclosure.
It checks today's price at every store, compares the alternatives and answers in about a minute.