Prices are checked against each store and labelled with when.
It checks today's price at every store, compares the alternatives and answers in about a minute.
The Bambu Lab X2D Combo is a closed-frame 3D printer with two nozzles and a 256 × 256 × 260 mm build volume. The main nozzle prints the part while the auxiliary nozzle lays down a separate support material, so overhangs, internal channels and steep angles peel away clean instead of being cut out. The AMS feeds multiple filaments for multi-color prints, and a 300 °C hotend with a 65 °C heated chamber opens up engineering materials. It suits hobbyists and small shops stepping up from a single-nozzle open-frame machine; against single-nozzle rivals it trades a simpler design for cleaner supports and less purge waste.
In stockShips from Australia · duties may applyReturn policy
The Bambu Lab X2D is a dual-nozzle 3D printer. The main nozzle prints the part, and the auxiliary nozzle prints support material. This allows full support under steep overhangs, fabric folds and internal channels, which then peels away clean. Print quality from the auxiliary nozzle is slightly lower than from the main nozzle.
The two nozzles swap in a split second, which gives faster color changes, cleaner transitions and less waste. The swap uses a gear-and-trigger mechanism in the toolhead instead of an extra motor, so the toolhead stays light. A lighter toolhead means less inertia and vibration at full speed. PLA and TPU can be fused in a single model. Official Bambu Lab filaments are recommended for the auxiliary nozzle, especially official PLA for model printing. Third-party filaments on the auxiliary nozzle may not give the best print quality.
The 300 °C nozzle and 65 °C actively heated chamber suit most engineering filaments, such as ABS, ASA and nylon. The active chamber spreads heat evenly so layers bond from edge to edge. Dual left and right air intakes flush the chamber with cool air to stabilize each layer of low-temperature filaments like PLA. Flow Dynamics Calibration models the whole extrusion system and compensates for nozzle residue, nozzle wear and slightly damp filament.
