This is a second-generation dust collection throat plate for the Bosch CM10GD miter saw. It replaces the factory throat plate and installs with the factory screws. It is a two-piece solid plate with no opening. Once you cut into it, the opening is only as wide as the blade (zero clearance). That supports the material right up to the cut line, helps prevent tear-out, and keeps small offcuts from falling beneath the plate.
A shroud on the underside traps debris that would normally be pushed under the plate. It directs the debris to the rear, where a vacuum port pulls it out. The vacuum adapter connects to most extractors, shop vacuums and dust collectors. All fittings are tapered for a secure connection to many brands of hoses.
The plate is meant to be used with an aftermarket behind-the-blade collector, which is not included. That collector handles debris from the back half of the blade, and the throat plate captures what comes off the front. The throat plate should not be used as the primary source of dust collection. It is not intended for bevel cuts, which will destroy the shroud and the zero-clearance function. All miter cuts can be made as long as the blade is 90 degrees to the table.
- Compatibility
- Bosch CM10GD miter saw only; not tested or guaranteed on other makes or models. The model number is on the top side of the motor housing.
- Material
- 3D printed in PETG filament
- Construction
- Two-piece throat plate (front and rear sections) with built-in underside shroud
- Installation
- Replaces the factory throat plate and reuses the factory screws; vacuum port attaches to the rear section with four small screws (preinstalled)
- In the box
- Throat plate/shroud (front and rear sections), vacuum port, clear vinyl hose, vacuum adapter, bump stop
- Vacuum hose fit
- 2-1/2" dust collection hose, 2-1/2" shop vacuum hose, 1-7/8" shop vacuum hose, or 36mm Festool antistatic hose
- Tool-side ports
- One port for a 1-5/8" hose cuff from an aftermarket behind-the-blade unit; one port for the supplied 1/2" outside diameter vinyl hose or a 5/8" inside diameter hose (not included)
- Bump stop
- Keeps the saw head from fully returning to the factory chop position, so the blade does not cut too far into the vacuum port
- Not included
- Behind-the-blade dust collector
- Cut limits
- Not for bevel cuts; full range of miter cuts with the blade at 90 degrees to the table