This is an 18V cordless 18-gauge brad nailer that uses an onboard air-compression system to drive nails with force close to a pneumatic gun. It fires 15mm to 50mm brads from a 100-nail side-loading magazine and runs on a 4.0Ah Li-ion battery rated for up to 1,400 nails per charge. You can switch between sequential single-shot and bump firing, and set depth without tools. It suits trim carpenters, furniture and cabinet makers, and remodelers who want pneumatic-style driving without a hose or compressor. Against typical cordless brad nailers it stands out on capacity and firing modes; the trade-off is the weight and bulk of an 18V pack on a finish tool. Owners rate it highly, at 4.8 from 115 ratings.
In stockShips from the UK · duties may applyReturn policy
Owners rate it 4.8 out of 5 across 115 ratings and describe it as a dependable cordless substitute for a pneumatic brad nailer. They like the consistent flush driving and the long runtime per charge.
This cordless 18V finish nailer drives 18 gauge brad nails up to 50mm long. It is suited to furniture, door and stair construction, and skirting board or panelling installation.
It uses Air Press technology. The motor drives an internal piston assembly that compresses air in the onboard cylinder. When the gun is actuated, the compressed air drives the firing pin forward and sets the nail. This gives consistent flush driving and less recoil, and is easier to maintain than a traditional air nailer.
The side-loading magazine takes 18 gauge brad nails from 15mm to 50mm and holds 100 nails. A window on the side of the magazine shows when it is running low. You can choose full sequential firing, single shot nailing, or contact (bump) firing for rapid fastening.
