
Delta UHMW Zero Clearance Table Saw Insert Approx Dims 13-3/8in x 3-3/4in x 1/2in
Best price now
Prices are checked against each store and labelled with when.

Prices are checked against each store and labelled with when.
It checks today's price at every store, compares the alternatives and answers in about a minute.
This is a replacement table saw insert for Delta saws, cut from UHMW plastic to roughly 13-3/8 by 3-3/4 by 1/2 inches. You raise the blade through it to cut a zero clearance slot, which supports stock right up to the teeth and closes the gap that lets thin offcuts drop in. That tighter slot reduces tear-out on veneered and crosscut stock and limits the chance of kickback from a trapped piece. It works with standard and thin-kerf carbide blades and with dado stacks, though the maker advises a separate insert for each setup. Compared with factory inserts, it gives better support around the blade but must be dedicated to one blade width.
In stockSold by Peachtree Wood Working IncReturns: Sold by a Walmart Marketplace seller; returns go to the seller under the seller's returns policy.
This is a zero clearance table saw insert made of UHMW, sized to replace the factory insert on a Delta table saw. It measures approximately 13 3/8 in x 3 3/4 in x 1/2 in.
The insert is used by raising the blade up through it, so the cut is made in the insert itself. That closes the gap between the side of the insert and the blade, which gives the stock more support than most factory inserts and keeps small pieces from dropping into the opening.
It works with any standard carbide-tipped saw blade, standard or thin kerf, and with dado blades. For both a standard blade and a dado blade, two separate inserts are recommended: one for normal cuts and one for dado cuts.