Dewalt 20V MAX 2-Tool Combo Kit - DCK250QQ2

Key Features

Heavy-Hitting Drill Power

The included DCD806 hammer drill is built for tougher drilling and anchoring work, with up to 109% more power than the DCD778. That matters when you are moving between wood, metal, and light masonry and do not want the tool to bog down.

Compact Impact Driver

The DCF845 impact driver gives you a compact fastening tool with 3 speeds and 30% more torque than the DCF885. You get better control for cabinet screws and enough output for larger fasteners on site.

Ready-To-Work Kit

This DeWALT combo kit comes with two 4.0Ah POWERPACK batteries, a charger, belt hooks, and a contractor bag. That means less piecing together extras and more getting to work right out of the box.

Overview

The DeWALT DCK250QQ2 20V MAX XR 2-Speed Hammer Drill & Impact 2-Tool Combo Kit is a cordless power tool combo kit built for drilling, hammer drilling, and fastening across a wide range of jobsite tasks. This is a power tools combo kit designed for general drilling, anchor setting, and screw fastening in wood, metal, and masonry. Model Number DCK250QQ2 pairs the DCD806 1/2 inch hammer drill with the DCF845 1/4 inch impact driver, then backs them up with two 20V MAX XR POWERPACK 4Ah batteries so you are not starting with a bare-tool setup.

The big story here is balance. The hammer drill is DeWALT's most powerful 20V MAX 2-speed hammer drill in this class, and it gives you a 2-speed transmission with a variable speed trigger and no-load speeds of 0-650 and 0-2,000 RPM. In plain terms, that gives you the low-speed control needed for bigger bits and tougher materials, plus the higher speed you want for faster drilling in lighter work. If you bounce between rough carpentry, service calls, and install work, that range matters more than a spec sheet brag line.

The impact driver rounds the kit out the right way. Instead of tossing in a stripped-down second tool, DeWALT includes the DCF845 XR 3-speed impact driver with a brushless motor, 1,825 in-lbs of torque, and up to 3,400 RPM. That gives you a real fastening tool for structural screws, ledger work, electrical hardware, and day-to-day assembly tasks. The 3-speed selector is especially useful because you can back it down for more control when you are driving smaller fasteners or working with finish materials, then step it up when the job turns into repeated heavy fastening.

DeWALT also paid attention to the parts you use every day. The DCD806 hammer drill has a 1/2 inch metal ratcheting chuck for stronger bit grip, which is exactly what you want when drilling harder materials or using larger accessories. The DCF845 uses a 1/4 inch quick-connect hex chuck, so swapping impact bits is fast and simple. Both tools use brushless motors, which is the right move for runtime, efficiency, and lower maintenance compared to brushed tools.