Compared across 15 stores. Prices are checked against each store and labelled with when.
It checks today's price at every store, compares the alternatives and answers in about a minute.
The DeWalt DCN920B is a cordless 21-degree plastic-collated framing nailer that runs on DeWalt's 20V MAX batteries, so there is no compressor or hose to haul. Its brushless motor and active flywheel keep it ready between shots, and DeWalt rates it for up to 530 square feet of subflooring or 100 feet of wall framing per charge on a 5.0Ah pack. It takes nails up to 3-1/2 inches, which covers wall framing, subfloor and toe-nailing. This bundle adds a 4.0Ah battery two-pack and the DCF921B 1/2-inch impact wrench, making it a starter set for a framer already on the 20V platform. Against pneumatic framers it trades raw speed for setup-free mobility; against other cordless framers it is a proven, widely used design.
In stock
In stock
In stock
In stock
In stock
In stock
In stockReturn policy
Availability unknown
Availability unknown
Availability unknownSold by essentialsdepot24
Availability unknown
Availability unknown
Availability unknown
Availability unknownSold by The Factory Depot
Availability unknown
Store links may earn us a commission.
Lowest price we've seen: $287.04 on Nov 12 at Arbor. Tracked across 14 stores since Nov 12.
Owners rate it highly, with a 4.7 average from 20 ratings. Framers like the hose-free setup and the fast follow-up shots; the main complaints are weight and the need for larger batteries.
The DEWALT DCN920B is a 20V MAX XR brushless cordless framing nailer. It drives 21-degree plastic collated nails up to 3-1/2 inches long and needs no compressor or hose. It is made for wall framing, subfloor installation, toe-nailing and general structural fastening.
A brushless motor and an active flywheel keep the tool ready between shots. The flywheel stays active for 6 seconds after the trigger is released, which cuts the wait between nails in rapid sequential mode. It drives up to 72% more sub-flush than the previous generation. With a 5.0Ah battery, it drives up to 530 square feet of subflooring or up to 100 feet of wall framing per charge.
The tool weighs about 8.65 lbs without a battery. It has a high-strength magnesium magazine and a nose redesigned for toe-nailing, for better alignment and grip at steep angles. The springs and driver blade can be serviced in the field. It is Chip-Ready for the TOOL CONNECT system, using a separately sold tracking chip.
