

The DeWalt DWS715 is a corded 12-inch compound miter saw with a single bevel and a 15 Amp motor that spins the blade at 4,000 rpm. Its stainless steel miter detent plate has 14 positive stops and a cam miter lock, and the tall sliding fences hold 5-1/2 inches of base molding upright and the same of nested crown. It is a straightforward framing and trim saw for people who cut miters and bevels on one side only; saws with dual bevel let you tilt either way without flipping the work, and slider saws crosscut wider stock, but this one keeps the setup simple and the weight down with a built-in carry handle. Owners rate it highly for accuracy out of the box and steady power in thick stock.
In stockReturn policy
Owners rate the DWS715 highly and describe clean, square cuts out of the box and a motor that does not bog down in dimensional lumber. Complaints center on the single bevel, modest crosscut width and dust collection that leaves a lot on the floor.
The DeWalt DWS715 is a 12 in. single-bevel compound miter saw with a 15 Amp motor and a 12 in. carbide tipped blade. It cuts 2 in. x 8 in. dimensional lumber at 90° and 2 in. x 6 in. dimensional lumber at 45°.
The stainless steel miter detent plate has 14 positive stops, and a cam miter lock holds the setting. The tall sliding fence supports 5-1/2 in. of base molding vertically and 5-1/2 in. of crown molding vertically nested. The saw bevels from 0° to 48° to the left and 0° to 3° to the right.
It weighs 36 lbs and has a built-in carry handle. A dust bag, vertical clamp and wrench are included.
It checks today's price at every store, compares the alternatives and answers in about a minute.







