It checks today's price at every store, compares the alternatives and answers in about a minute.
This is a two-piece zero-clearance throat plate for the DeWALT DWS779 and DWS780 miter saws, sold as an aftermarket upgrade to the factory plate. The Gen 2 design adds an underside shroud and a vacuum port that routes debris to the rear for extraction, and it installs faster than the first generation. It suits owners who want cleaner cuts with less tear-out and less dust escaping under the saw. Against the stock plate and the Gen 1 version, it offers better dust capture and a tidier factory look, though it is a single-purpose accessory rather than a saw upgrade.
In stockReturn policy
Owners rate it highly, with 4.7 out of 5 across 72 ratings. The common thread is better dust capture and cleaner cuts than the factory plate, with the zero-clearance slot doing what it promises.
This is a two-piece, zero-clearance throat plate that replaces the factory throat plate on DeWALT DWS779 and DWS780 miter saws. It is 3D printed from PETG filament and installs using the saw's factory screws. The plate has no opening until you cut into it, so the first cut leaves a slot only as wide as the blade.
That narrow slot supports the material right up to the cut line, which helps prevent tear-out and keeps small offcuts from dropping beneath the plate. A shroud built into the underside traps debris that would otherwise be pushed down under the plate and forces it to the rear, where a vacuum port evacuates it. A clear vinyl hose runs from that port to the vacuum adapter, and a rail stop keeps the saw head from returning all the way to the chop position so the blade does not cut into the vacuum port.
The plate is meant to be used with an aftermarket behind-the-blade collector, which is not included, and it is not designed as a primary source of dust collection. It is not intended for bevel cuts, which will damage the shroud and the zero-clearance fit, but the full range of miter cuts can be made as long as the blade is at 90 degrees to the table. On some early-model saws, a small rectangular piece of plastic inside the blade trough keeps the front section from seating and can be cut out with a sharp blade.