Prices are checked against each store and labelled with when.
The DMI Wheelchair Seat Belt and Safety Harness is a 48-inch by 1.75-inch belt that mounts across the backrest of a wheelchair to keep a seated user from sliding forward or falling out. It installs with the two bottom backrest screws, which pass through metal grommets on the belt, so no drilling or extra hardware is needed. The buckle works like a car seatbelt and the strap length adjusts. It suits caregivers of people with spasticity, seizures or poor trunk control who need a simple positioning belt rather than a full postural harness. It is a basic two-point lap belt, so it does less than chest or four-point harnesses, and it is not a substitute for supervision.
In stockSold by HealthSmartReturns: Sold by a Walmart Marketplace seller; returns go to the seller under the seller's returns policy.
Buyers rate it well overall and mostly describe it as an easy, sturdy belt that installs in minutes. Some note the strap is shorter or thinner than expected and that the buckle is a standard push-button type.
The DMI Wheelchair Seat Belt and Safety Harness is a belt that adds restraint and security for a person sitting in a wheelchair. It measures 48 in long and 1.75 in wide.
The belt works much like a car seatbelt: it fastens across the lap and adjusts easily, and it is made to fit comfortably. The belt is intended for people with spasticity or seizures, or who are at risk of falling out of the wheelchair.
To install it, remove the bottom screws from the left and right sides of the wheelchair backrest. Insert those screws through the grommets on the belt, then put the screws back into the screw holes and tighten them.
It checks today's price at every store, compares the alternatives and answers in about a minute.





