A stainless steel CB antenna bracket that bolts to an inner door jamb or tailgate hatch, with a 180-degree swivel stud so the antenna can be set vertical even on slanted jambs. It suits vans, pickups and SUVs where a permanent body mount is unwanted, since the screws sit on the inner edge and leave no visible holes outside. The kit includes the K-4T2 stud and 18 feet of RG8X coax, so it is a complete install rather than a bare bracket. It is rated for antennas up to 4 feet, which covers a Firestik II but not a long whip.
In stockReturn policy
Buyers rate it well made and easy to install, and like that the swivel lets them mount on angled jambs and still get a straight antenna. Complaints center on the included screws and on running the pre-made coax into the cab.
A stainless steel CB antenna mount kit for installing an antenna on a vehicle's inner door jamb or tailgate hatch. The kit contains the door jamb mount, a PL-259 antenna stud and 18 feet of RG8X coax cable.
The bracket is 1.5" (38 mm) wide with a 2" (50 mm) reach and is 4.2" (105 mm) long overall. Four holes in the mount secure it with screws or bolts, and the mount can be used as a template to mark the holes before drilling; the pilot drill size is #20, 0.161". The mounting screws sit on the inner edge of the jamb, so no holes are visible in the vehicle.
The stud bracket swivels a full 180 degrees, 90 in each direction, so the antenna can be set straight and vertical whatever the angle of the jamb. It can go on the driver or passenger side door, and it is recommended for antennas up to 4' tall.
It checks today's price at every store, compares the alternatives and answers in about a minute.





