
DroneThermal v4
Best price now
Prices are checked against each store and labelled with when.

Prices are checked against each store and labelled with when.
It checks today's price at every store, compares the alternatives and answers in about a minute.
The DroneThermal v4 is a tiny analog thermal camera board for small FPV drones and fixed surveillance setups. It weighs 2.3 g without the thermal core and measures 20 x 20 x 10 mm, so it fits builds where a full thermal camera will not. It accepts FLIR Lepton cores at 160x120 or 80x60 and outputs analog PAL or NTSC video over three wires, which suits pilots and tinkerers already running analog FPV gear. It is not a standalone camera: you must supply a Lepton core, and the onboard WiFi is limited to firmware updates for now. Compared with integrated thermal cameras, it is far smaller and simpler, but it gives up digital output, onboard recording and plug-and-play setup.
In stockReturn policy
DroneThermal v4 is a micro analog thermal camera for small UAVs and surveillance. It takes a FLIR Lepton thermal core, sold separately, and supports both 160x120 and 80x60 pixel cores. Without the core it weighs 2.3 grams and measures 20 mm x 20 mm x 10 mm.
Video comes out as a standard 75 Ω analog signal over a three-wire connection: V+, ground and video out, so it can go straight to a monitor or video gear. It outputs 25 Hz PAL or 30 Hz NTSC, and the thermal image refreshes at under 9 Hz. The board runs on 3.3 V to 5 V, with a 3.6–4.2 V 1S LiPo ideal, and draws 160 mA continuous, or 350 mA when the FFC shutter is closed.
A single button on the back changes the color palette and starts FFC calibration when held for about 5 seconds. Eight palettes are available; the default Iron Black shows the warmest 20% of a scene in yellows and purples and the cooler 80% in black and white, while Ironbow shows hot objects in lighter warm colors and cold objects in dark cool colors. The onboard 2.4 GHz WiFi is used for firmware updates in the current firmware: hold the button while powering on, connect to the camera's access point, and upload the update file in a web browser.