It checks today's price at every store, compares the alternatives and answers in about a minute.
The DXC Extruder is a drop-in replacement extruder for Creality K1, K1C, K1 SE and K1 Max printers. Its helical gear system and U-shaped wheel engage filament gradually, which the maker says cuts filament wear by 60% and avoids the flat spots and deformation marks straight-cut gears leave. A dual-gear drive doubles the contact area for stronger grip and steadier feeding, aimed at reducing slippage and vertical fine artifacts (VFA) on prints. It suits K1 owners chasing cleaner walls and fewer feed problems; it is a hardware upgrade, not a new printer, so gains depend on the rest of your setup.
In stockShips from China · duties may applyReturn policy
Buyers rate it 5 out of 5 across 25 ratings, with no critical feedback recorded.
This is an upgraded DXC extruder built for Creality K1C, K1, K1 SE and K1 Max printers. It swaps in without firmware rooting, so you replace the unit and print. It feeds PLA, ABS, TPU in 95A to 85A, and carbon fiber (CF) filaments.
A helical gear system drives the filament with spiral teeth and a U-shaped wheel that engage it progressively. The dual-gear, dual-drive structure doubles the contact area for grip and keeps feeding steady during high-speed work, which limits slippage and vertical lines (VFA) on prints. The gears carry a patented RNC ultra-wear-resistant coating.
An adaptive rocking arm sets pressure according to filament hardness, so no manual tweaking is needed, and a built-in smart detection system monitors feeding in real time to limit waste and mess during runouts or multi-material switches. An open cooling architecture is designed to prevent thermal creep in high-temperature, long-term use.