
Price facts
- Lowest price today: $15.00 at Evolve Skateboards USA (checked Nov 20, 2026).

The Evolve CNC Motor Plate is a machined replacement mount for the motor on Evolve electric skateboards. It is sold as a single plate and is matched to specific truck and motor generations, so the right version depends on your board. It suits owners repairing or upgrading a worn or bent mount rather than riders buying a new board. As a spare part it competes only with Evolve's own stock plates and third-party mounts, and its value comes from a precise fit and the correct bolt pattern for your setup.
In stockReturn policy
Buyers rate it well overall, with the fit on the listed truck and motor combinations the main point of praise. Complaints center on getting the right version and on the work involved in swapping the plate.
A replacement motor plate for Evolve Skateboards, machined from CNC.
The plate fits SC2/3000W and 3500W boards — Renegade, Diablo, Fusion and Stoke X — and boards upgrading to SC2 trucks. It also fits SC1/3000W boards (Hadean and GTR2) and SC1/1500W boards (Stoke 2, GTR1, Stoke 1, GT, GTX and GT ONE).
To swap the plate, turn the board off and remove the P-clips on the rear base plate by undoing the nuts and bolts; this step does not apply to the Hadean or GTR2. Disconnect the motor connectors, then remove the wheel, belt cover, belt and drive gear. Take out the four screws holding the motor and lift the motor off the board, then repeat the steps in reverse to install the new motor. Set the belt tension correctly afterwards. The bolt head size is 1/8 inch.
It checks today's price at every store, compares the alternatives and answers in about a minute.