Adam's Graphene Ceramic Spray Coating Basic Kit pairs a 12oz graphene-infused spray coating with two borderless grey towels and two microfiber applicators, so you can coat paint, glass, headlights, chrome, trim, wheels and even bed liners in one session. Adam's claims it is its longest-lasting spray coating, rated over 9H hardness with a year or more of protection, and adds graphene for less water spotting, better stain and scratch resistance, and easier application than earlier ceramic sprays. The UV Tracing Technology lets you check coverage under a UV light. It suits DIY detailers who want ceramic-like protection without a full coating job, though it is a spray sealant rather than a multi-year professional coating and cannot ship by air.
In stockReturn policy
Rated 4.9 out of 5 from 32 ratings, buyers are highly positive about the graphene spray coating. They report easy application and strong water beading, and many say it lasts well when the surface is prepped properly.
This kit contains a graphene-infused ceramic spray coating for vehicles. It is a spray-and-wipe product that goes on in minutes. It can be used on its own or as a topper over an existing ceramic coating. The formula uses Ceramic Glow Technology and UV Tracing Technology, so the coating glows bluish under 395 nm UV light. It is clear and invisible under standard light.
The coating can be used on painted surfaces, glass, headlights, chrome, plastic trim, wheels, bed liners, tonneau covers, canvas tops, floor mats and unfinished metal. It is rated at greater than 9H hardness and 1+ years of protection. Water evacuates at sliding angles under 10-15°, and contact angles average 110-118°.
To apply, spray the product onto a microfiber applicator or microfiber towel and wipe it over the surface until it is fully covered. Let it dry for 1-2 minutes, then buff to a high shine. Allow 4 hours to cure before exposure to the elements. Work panel by panel for thorough coverage and control of overspray. Layering beyond 3 coats adds no extra benefit. For best results, first remove contamination, oxidation and swirls with a clay bar or mitt and a swirl remover. Then wipe off surface oils with a surface prep product.
