
Hifonics ZD-1950.1D 1950 Watt Mono Car Audio Amplifier 1 Ohm Class-D
Best price now
Prices are checked against each store and labelled with when.

Prices are checked against each store and labelled with when.
It checks today's price at every store, compares the alternatives and answers in about a minute.
The Hifonics ZD-1950.1D is a Class-D mono block amplifier from the Zeus Delta line, rated at 1950 watts and stable down to 1 ohm. It uses a PWM MOSFET power supply, a low-noise preamp circuit and nickel-plated RCA inputs, and it ships with a Rockville 2-gauge amp installation kit with an ANL fuse holder. It suits drivers powering a single subwoofer or a small sub stage who want big Class-D output on a budget. Against premium mono amps it gives up some refinement and clean-power headroom, but it costs far less than name-brand competition amps of similar rating.
In stockReturn policy
Owner feedback on Hifonics Zeus Delta mono amps is mixed. Buyers like the output for the money and the easy sub-stage install, but some report the amp not reaching its claimed power and running hot under heavy load.
The Hifonics ZD-1950.1D is a mono Class D car audio amplifier rated at 1950 watts at 1 ohm, with 975 watts at 2 ohms and 450 watts at 4 ohms. It runs a single channel only. A PWM MOSFET power supply and a dual-coil Simpatico coil design keep voltage constant through the output devices with minimal heat.
The amplifier is built on an aluminum heat sink for heat dissipation, with secure molded terminals for power, ground and speaker connections angled for easier access and clean wire routing. Power cable connects at 4 AWG and speaker cable at 12 AWG. RCA inputs are nickel plated for secure, corrosion-resistant connections, and an external 100A fuse handles protection.
Onboard controls include a variable electronic crossover with a 50Hz–250Hz low pass slope of 12dB per octave, a 15Hz–40Hz subsonic filter, a bass boost of 0 to 12dB and built-in bass control. A DC Signal Sense switch turns the amp on when a signal reaches the RCA inputs, so no remote turn-on wire is needed, and the feature can be switched off. A bass remote is included, and LED indicators on the end panel monitor overload and speaker short protection.







