This home tanning lamp has a wide LED panel on a bendable gooseneck arm. The arm sits on a polished telescopic pole, which stands on a weighted base plate. You can set it down anywhere near a mains socket. Nothing is drilled, clamped or fixed to the wall.
The panel is filled edge to edge with LEDs at two wavelengths, 460 and 490 nm, both in the visible blue part of the spectrum. Because it is an LED array, there are no tubes to unscrew or replace.
You sit, lie or stand in front of the lamp. Set the minutes and an intensity level on the wired handset, which hangs on the cord at about waist height. The display counts down, and the panel switches off on its own when the timer ends. Put on the supplied anti-glare glasses before you switch the panel on, and keep them on for the whole session.
- Light source
- LED panel, dual wavelength, 460 nm and 490 nm
- Power
- 30 W blue-light circuit, runs from a mains socket
- Timer
- Set on the handset, up to 30 minutes, with countdown display and automatic shut-off
- Intensity
- Levels 1 to 5, plus M mode
- Controls
- Wired handset on the cord
- Height
- Telescopic pole, 0.65–1.86 m (25.6–73.2 in)
- Aiming
- Bendable gooseneck arm
- Base
- Flat weighted plate, stands on the floor
- Assembly
- By hand, no tools needed. The pole screws into the base and the panel arm fits to the pole.
- In the box
- LED panel head on gooseneck arm with wired handset, telescopic pole, weighted base plate, anti-glare glasses