Prices are checked against each store and labelled with when.
It checks today's price at every store, compares the alternatives and answers in about a minute.
A set of four trailer hub and drum assemblies for 5,200–6,000 lb axles with a 6-on-5.5" bolt pattern. Each unit comes with inner and outer bearings, pre-installed races, grease seals, grease caps with plugs, cotter pins and 24 cone wheel nuts, and the hubs have 1/2" studs pressed in. They are built for 12" x 2" brakes, so they fit cargo, utility, equipment and RV trailers that use that setup. The main draw is completeness: one box covers all four wheel ends, which saves chasing bearings, seals and nuts separately. Buyers rate it highly, and the recurring praise is that it goes together without surprises.
In stockReturn policy
Buyers rate the set very highly and describe it as a straightforward full wheel-end replacement. The common thread is that everything needed for the job arrives together and fits as expected.
This set of 4 hub and drum assembly kits is made for full wheel-end replacement on trailer axles rated 5,200 to 6,000 lb. It suits tandem axle setups and works with standard 12" x 2" trailer brakes. It can be used on cargo, utility, equipment, and RV trailers.
Each hub has a 6-lug, 6 on 5.5" bolt pattern. The bearing races are pre-installed, and the 1/2" wheel studs are pre-pressed into the hubs, which simplifies installation.
Each kit includes inner and outer bearings, a grease seal, a grease cap with plug, and cotter pins. Cone wheel nuts are also included, so fewer wheel-end parts need to be bought separately.
