This is a magnetic embroidery hoop for machine embroidery. It measures 9.5 x 14 inches (240 x 355 mm). It uses long-bar magnets instead of round or spot magnets, which apply even pressure across the frame to hold fabric flat.
The bottom frame is solid metal with a soft coating. The coating helps keep fabric from scratching or sliding during embroidery. The hoop holds fabric without screws or clamps, and it leaves no hoop marks. The upper frame is a set of separate magnets, so you can lift and adjust one magnet without re-hooping the whole frame. You can also position the magnets to avoid zippers or uneven areas.
To use it, mark the center of the embroidery area on the fabric. Place the backing paper and fabric on the frame in order. Fix the fabric with the long magnets, and gently scrape the embroidery area with a magnet to keep it flat. Then insert the frame into the machine slot and start embroidering.
- Hoop size
- 9.5 x 14 in (240 x 355 mm)
- Magnets
- Long-bar magnets
- Bottom frame
- Solid metal with soft coating
- Compatibility
- Brother BP3700, BP3600, CX1E, XE2, XE1, XJ2, XJ1, XV8550D, XV8500D
- In the box
- 1 magnetic embroidery hoop (240 x 355 mm), 10 long-bar magnets, 2 small magnets, 1 grid template