LECTROSONICS HMa/E01

This unique plug-on transmitter design will ideally match any microphone or line level source via a standard XLR connector. Phantom power is selectable at 5, 15 and 48 volts, or can be turned off for use with dynamic microphones and line level signal sources.

The design includes a wide tuning range of up to 76MHz, with tuning steps in increments of 100kHz or 25kHz for up to 3072 frequencies. The tuning range covers three standard 25.6MHz Lectrosonics frequency blocks. Each of the standard blocks includes 256 different pilot tone frequencies for compatibility with all "Digital Hybrid Wireless" receivers.

DSP compatibility modes are also included to work with legacy Lectrosonics analog wireless microphone receivers and IFB receivers as well as some receivers from other manufacturers. The PHTRAN3 leather pouch with belt clip and snap close is included.

"Digital Hybrid Wireless" combines 24-bit digital audio with an analog FM radio link to provide outstanding audio quality and the extended operating range of the best analog wireless systems. The design overcomes channel noise in a dramatically new way, digitally encoding the audio bitstream in the transmitter and decoding it in the receiver, yet sending the encoded information via an analog FM wireless link. This proprietary DSP algorithm eliminates a compandor circuit and its artifacts and preserves the RF spectral footprint of analog FM designs to simplify multi-channel coordination with exisiting analog wireless systems.

FEATURES:

• "Digital Hybrid Wireless" technology

• membrane switch control panel with LCD display

• converts microphones with XLR jacks to wireless operation

• selectable 5, 18 and 48 volt phantom power plus off position for dynamic microphones

• adjustable low frequency roll-off

• powered by two AA batteries

• 256 synthesized UHF frequencies

• 50mW output power

• rugged machined aluminum housing