The Majestic Trilliant 25" Direct Vent Gas Insert turns an existing wood-burning fireplace into a remote-started gas fire. It has 7 hand-painted oak logs over glowing embers, set against Canyon Brown brick interior panels. It is certified for bedrooms and bedsitting rooms.
It is a direct vent unit. It draws its air from outside through two 3 in. flex liners and sends exhaust out the chimney. IntelliFire Touch ignition has a USB-C battery backup for power outages. The IFT-RC400 touchscreen remote has a thermostat mode, and a fan is factory installed.
The insert goes into a masonry wood-burning fireplace or a UL127 listed factory-built fireplace with a non-combustible chimney in good working order. A decorative front and a surround are needed to finish the installation and are purchased separately.
- Heat output
- Up to 27,000 BTU/hr on natural gas, up to 25,000 BTU/hr on propane
- Viewing area
- 22-1/4" x 12-3/16" ceramic glass
- Insert size
- 26-1/8" wide at front, 17-1/16" high, 14-1/2" deep
- Opening needed
- Width 26-5/8" at front and 15-1/8" at rear; height 17-5/16" at front and 15-1/4" at rear; depth 15"
- Clearance
- Opening sizes assume 1/4 in. of clearance on all sides; add 4 in. of height if the exhaust collar and damper do not line up
- Logs
- 7-piece hand-painted oak log set with glowing embers and mystic embers
- Interior
- Canyon Brown brick interior panels and a decorative brick base
- Ignition
- IntelliFire Touch electronic ignition
- Remote
- IFT-RC400 touchscreen remote with thermostat mode
- Fan
- Factory installed
- Battery backup
- USB-C port; battery pack for 4 AA batteries (batteries not included)
- Venting
- Direct vent, two 3 in. flex liners up an existing chimney to a vertical termination; 10 ft minimum and 50 ft maximum vertical run; horizontal termination not allowed; needs its own vent system, not a
- Venting kits
- LINK-DV and LINKSQ kits include the liners, termination cap and flashing; LINK-ZC-ADPB adapts them to Class A pipe in a factory-built fireplace
- Extending vent
- SLP 6-5/8 in. pipe connects with the DV-46DVA-GK adapter; up to four 45 degree elbows in that section, no 90 degree elbows
- Gas line
- 1/2" gas line to the shut-off valve
- Electrical
- 110-120 VAC outlet for the supplied power cord
- Compatibility
- Masonry wood-burning fireplace or UL127 listed factory-built fireplace with a non-combustible chimney in good working order
- Room rating
- Certified for bedrooms and bedsitting rooms
- In the box
- Insert with log set, embers, brick interior panels and brick base, ceramic glass, IFT-RC400 remote, factory installed fan, battery backup, power cord, manual gas shut-off valve, flexible gas connector
- Required separately
- Decorative front with built-in barrier screen, surround, 3 in. flex liner venting kit with termination cap, 110-120 VAC outlet, 1/2" gas line
- Optional
- Custom surround, USB-C relocation kit, wireless wall switch, Wi-Fi module, reflective black glass interior panels; the insert operates without them
- Mantel clearances
- Mantel legs and wall projections are charted in Figures 3.15 and 3.16 and Tables 1 and 2 on page 18 of the installation manual; combustible mantels in Figure 3.17 on page 19