
Price facts
- Last seen at $14.99 at Foam Technician on Nov 17.

A 3D-printed barrel insert that converts the Nerf Mega BigShock from Mega darts to Elite darts. It raises average velocity from about 52 FPS to about 84 FPS, roughly a 63% gain, from the rechambering alone. Installation is a friction fit held by two o-rings after the dart post is removed, and it can be pulled out to shoot Mega darts again. It suits modders who want a quick, reversible power boost without opening the blaster; the trade-off is a printed PLA part with possible blemishes and no metal or sealed-breech upgrade.
In stockReturn policy
Rated 5 out of 5 from 35 ratings. Buyers report the conversion works as described, with a clear velocity jump and simple installation.
The Elite Magnum Conversion is a 3D printed barrel that rechambers a Nerf Mega BigShock blaster to fire Elite darts instead of Mega darts. It is a cosmetic and performance part, printed in PLA at 0.2 mm resolution. Because it is 3D printed, minor blemishes may be present.
With the stock blaster firing Mega darts, the BigShock has an average velocity of 52 FPS. With the conversion installed it fires Elite darts at an average velocity of 84 FPS, roughly a 63% increase from this mod alone.
The wide bore faux barrel tapers into the inner barrel, acting as a funnel that aids loading: a dart loads at any angle as long as its tail end is in the wide faux barrel. To install, remove the dart post from the blaster and slide the barrel in; two silicone o-rings hold it in place with a friction fit. It stays secure but can be removed to go back to shooting Mega darts. Leaving PLA parts in high heat will cause them to warp.
It checks today's price at every store, compares the alternatives and answers in about a minute.