This is a small belt-driven drill press for precise holes in jewelry, watch parts, circuit boards and model brass. The body is aluminum, and it is compact enough to sit on the corner of a bench. Its chuck takes bits from 0.3 to 4 mm, so a 0.3 mm bit can go straight down onto a marked spot.
A dial on the power adapter sets the speed from 400 to 4500 rpm. The head swings 360° and slides up and down the 13 mm column. It drills wood, plastic and circuit board up to 4 mm, and brass and aluminum up to 1 mm.
The press arrives in three pieces: head, column and base. Slide the column in, set the head on it and tighten two screws. It is built for drilling, not milling, because milling puts side load on the bit and needs an ER11 collet spindle in place of the chuck.
- Model
- TZ-525
- Body
- Aluminum
- Drive
- Belt
- Chuck
- Takes bits from 0.3 to 4 mm
- Speed
- 400 to 4500 rpm, dial on the power adapter
- Power
- 30 W, 12 V
- Adapter input
- 100 to 240 V wall power
- Column
- 13 mm diameter
- Head
- Swings 360°, slides up and down the column
- Drilling capacity
- Wood, plastic and circuit board up to 4 mm; brass and aluminum up to 1 mm
- Dimensions
- 100 × 80 × 180 mm
- Assembly
- Three pieces (head, column, base); two screws to tighten
- Bench Kit
- Press, speed-control adapter, chuck key, 3 mm hex key, spare belt
- Bench Kit + Bits
- Bench Kit plus a 10-piece cobalt drill set, 0.5 to 3 mm
- Watchmaker Kit
- Bench Kit plus a drill press vise, a 3.5 in clamp-on bench vise and a dial indicator with magnetic base
- PCB Kit
- Watchmaker Kit plus a 10-piece cobalt drill set, 0.5 to 3 mm, and an automatic center punch