A precision aftermarket mitre gauge for table saws and router tables, built around a hardened anodised aluminium bar with four expansion discs that take up side play in channels from 18.5 to 19.9mm. The 4mm steel plate carries 27 machined V stops at 5° increments plus ±22.5° stops, laser graduated in 1° steps through ±60°, and locks with a brass knurled knob. A phenolic sub plate protects the machine bed, and a removable 23.5mm steel disc fits standard 19mm T track. It suits woodworkers who want repeatable, no-play angles without upgrading the whole saw, and it sits well above the stamped gauges that ship with most saws.
In stockShips from the UK · duties may applyReturn policy
Rated 4.9 out of 5 from 81 ratings, owners treat it as a serious step up from stock saw gauges. They single out the no-play bar fit and the crisp V stops as the reasons it holds angles.
This mitre gauge comes with a mitre fence and a flip stop. It is made for table saws and router tables. The mitre bar is hardened anodised aluminium and has 4 expansion discs for a no-play fit with friction-free travel. An allen key adjusts the discs to fit mitre gauge channels from 18.5 to 19.9mm wide. A removable 23.5mm steel disc at the end of the bar gives a no-play fit in industry standard 19mm T track.
The gauge plate is 4mm thick steel, attached to the fence with a 5mm thick machined aluminium casting. A phenolic sub plate underneath is designed to prevent scratching or marking of the machine bed. The plate has 27 machined V stops at 5° increments, with special stops at plus and minus 22.5°. It is laser graduated in 1° increments across plus and minus 60°. A V-shaped steel cursor seats in the V grooves and locks with a brass knurled knob. The casting that holds the fence has two micro adjustment screws for calibrating the fence so it is true.
The fence is an aluminium extrusion with a ribbed face to keep wood from slipping. A steel scale on top has permanently etched 1mm graduations from 0 to 440mm. The flip stop slides in the 19mm T track slot and has a visible pointer, adjusted with two brass knurl screws. Its arm is 100mm long, with no play under heavy load, for repeatable cuts.
