Prices are checked against each store and labelled with when.
It checks today's price at every store, compares the alternatives and answers in about a minute.
This is a 120V electric heated mat, 16 feet long and 14 inches wide, built to melt snow and ice on shingle roofs, steps, walkways and driveways. It uses a third-generation graphene heating core with copper conductors, tops out around 125°F, and has a 3D checkered anti-slip surface with drainage grooves. The IP67 waterproof PVC body and hot-melt sealed edges are meant to survive a full winter outdoors. It suits homeowners who want a plug-in, no-install way to clear roof edges and icy paths, though it is a passive melter rather than a fast snow blower and its long cord and fixed width limit where it fits.
In stockReturn policy
This is a 120V electric heated mat that melts snow and ice outdoors. It is made for clearing snow from shingle roofs, and it also works on roof ridges, stairs, lawns, factories, warehouses and pipes for freeze prevention. It comes with a 177 in power cord for roof use and is designed for simple installation and setup.
The mat is made of IP67 waterproof PVC that is sturdy and flexible, and its edges are sealed with a hot melt process. It uses a 3rd-generation graphene heating core with copper conductive wires. The mat reaches a maximum of 125°F and melts up to 3 inches of snow and 2 inches of ice per hour.
The surface has a 3D checkered texture for grip and stays flat without curling or sliding. It keeps its anti-slip performance when wet or covered with a thin layer of melted ice, and grooves drain the melted water. Before powering on, fully unfold the mat and keep it from touching, crossing or overlapping itself. Do not plug it in until it is fully spread out. To store it, cut the power, let it cool and coil it up. Do not fold it or use rivets or screws, which ruin the waterproofing.
