A 20W LED replacement for 32W T9 circular fluorescent tubes in oyster lights, using the four-pin G10q connector. It cuts running energy by roughly half and is rated to last up to six times longer than the fluorescent tube it replaces. Most owners can swap it in without an electrician. It comes in 4000K cool white or 6500K cool daylight. It suits anyone with a magnetic-ballast or starter-type circular fitting who wants to keep the existing fixture; fittings with a different tube size or connector need a whole new oyster light instead.
In stockShips from Australia · priced in AUD (A$29.95) · duties may apply
Rated 4.9 out of 5 from 60 ratings, buyers are largely satisfied with the brightness and the straightforward swap. Most mention the easy fit into existing oyster fittings and the cooler, brighter light.
This Philips circular LED tube replaces a 32W T9 circular fluorescent tube, so you can switch to LED without replacing the whole light fitting. It uses 20W and is a common upgrade for oyster lights. It cuts energy use and running costs by about 50% and lasts up to six times longer than a conventional T9 circular 32W fluorescent tube.
The tube has a G10q connector with four pins. It is about 30 cm in diameter and 3 cm thick. If your round fluorescent tube is a different size or has another connector, you may need to replace the whole fitting.
Fittings with a magnetic ballast have a starter. For these, replace the tube and the starter with the one supplied, and no electrician is required in most cases. Remove the original starter first. The supplied starter is made for LED circular lights and makes no electrical connection. Fittings with an electronic ballast have no starter and usually need an electrician to wire out the existing ballast before installation. A sticker is included to place inside the fitting to show that an LED tube is in use.
