This is a single aluminum miter bar, 3/4 inch by 3/8 inch by 36 inches, used to build jigs and fixtures for a router table, band saw or table saw. Seven countersunk mounting holes run along the top of the bar, along with one additional hole that is not countersunk. Nine tapped 10/32 inch holes are set into the side.
The top mounting holes are spaced 5 inches on center and the side mounting holes 4 inches on center, so the bar can be fastened in a range of positions. It is machined from high-precision aluminum with a polished finish, and the holes are clean and burr free. A set of 10-32 nylon adjustment screws is included for mounting.
- Material
- Aluminum
- Finish
- Polished
- Dimensions
- 36 x 0.8 x 0.38 in (3/4 x 3/8 x 36 in)
- Top holes
- 7 countersunk mounting holes plus 1 non-countersunk hole
- Side holes
- 9 tapped holes, 10/32 in
- Top hole spacing
- 5 in on center
- Side hole spacing
- 4 in on center
- Included
- 1 bar and a set of 10-32 nylon adjustment screws
- Count
- 1