ProVap EZ 110

FINALLY, the Vaporizer That You Can Use Standing Up! No Caps ! No Measuring ! No More Bending to Vaporize Hives ! We've totally revamped the EZ to make it easier to use. If you value your sore back (and all beekeepers have them :) this is the vaporizer for you, NO BENDING OVER to vaporize!!!! We've kept it electric (but have it in battery form) because with the new protocols calling for 3-4 grams per brood chamber (6-8 grams per hive), unless you have a limited number of hives or lots and lots of high ah batteries, you just can't vaporize many hives with batteries.

Just point the vaporizer stem into the hive opening, dip the open end of the delivery capsule into the oxalic acid then slide the capsule down the tube. That's it! This will release the OA from the capsule into the heating chamber. The capsule when dipped into the OA picks up 4 grams… 1/2 the amount for a double brood box hive. So, yes you have to vaporize 2x! How? Oxalic acid is normally slightly damp and the capsule uses the "stickiness" of the damp OA to capture the correct 4 gram amount. If your OA is very dry, slightly mist it with water.

This ProVap EZ is made from 304 stainless steel and comes in two connective pieces for easy transportation. You simple can't buy a better, easier to use sub $2,500 vaporizer than the EZ. We named it the ProVap EZ 110 because we took all the best properties of the original ProVap110, the first EZ and made this EZ the easiest vaporizer on the market to use!

Want to see it in action?

Instruction Guide:

This sublimator (a more accurate term than vaporizer, but we'll use the term vaporizer as most know it by this name) is strictly for use in a grounded 110 volt (3 prong) socket.

Operation:

You use the ProVap EZ in the front entrance.

Connect the vaporizer to your 110 volt power source. I like to use an inverter connected to 12 volt battery as it never fails (as maybe a generator would). The inexpensive Cen-Tech power inverters from Harbor Freight work great. It will take approximately 2 minutes to reach operating temperature. The red sequence readout will display 250 when ready.

Place the stem of the vaporizer in the front entrance. Then take the included capsule and dip it into the OA. The dampness of the OA will hold the OA in the capsule. Note: the capsule is constructed to hold 4 grams! Slide the capsule into the stem and place your thumb over the stem hole (this holds the steam from escaping). When the capsule descends to the heating chamber it will release the OA to start sublimating. The temperature will drop when that occurs. When the temperature again rises to 250, in about 20-30 seconds, you're finished. Turn the EZ upside down to release the capsule to move onto the next hive.