

ProWax MiniFit Filters are replacement wax guards for hearing aids with MiniFit receivers. Each guard presses into the receiver opening to block earwax, skin oil and debris that dull or cut out the sound. They fit Widex hearing aids that use the MiniFit receiver system, so check your receiver type before ordering. Owners rate them highly for restoring clear sound in minutes without a clinic visit, and the main trade-off is that they are a small, model-specific part rather than a universal fit.
In stockReturn policy
Owners report that a fresh guard brings back clear, steady sound almost immediately and saves them trips to the clinic. Most praise the simple press-in fit and the holder that keeps spares tidy. The common complaint is that the guards are very small and easy to lose.
ProWax MiniFit filters are wax guards for hearing aid receivers. Earwax, skin oil and debris collect at the receiver opening and can make a hearing aid sound dull or muffled, or cut in and out. A fresh guard takes the wax and oil so the receiver behind it stays clean and dry.
Each guard is a white plastic ring about the width of a grain of rice. The guards come in a holder, with each tool clipped into a disc. Every tool is double-ended: a fine pin at one end lifts the used guard out, and a fresh guard is already seated on the other end. You only handle the tool.
To change a guard, work over a clean, well-lit table, because the parts are small. Push the pin end straight into the used guard and pull it back out. Turn the tool around and press the fresh guard squarely into the receiver opening until it seats. The holder is smaller than a coin, so it fits in a hearing aid case.