

The TX16S MK3 is RadioMaster's flagship open-source radio, built on an STM32 H7 processor with EdgeTX and a 5-inch 800x480 IPS touchscreen. It pairs V6 quad-bearing Hall gimbals with a dual-band internal RF module (2.4GHz Gemini plus Sub-G 900MHz) and ships in an ELRS version. It suits FPV pilots, fixed-wing flyers and anyone who wants a full-feature radio with plenty of switches and telemetry. Against the original TX16S it adds the faster H7 chip, the touchscreen, the dual-band module and active cooling, which puts it near the top of the open-source radio class.
In stockReturn policy
Owners of the TX16S line praise the gimbal feel, the open EdgeTX firmware and the large color screen. The MK3's faster processor and touchscreen are the most-cited improvements. The main complaints are size and weight, and the learning curve of EdgeTX for newcomers.
The TX16S MK3 is a full-size radio controller built around the classic TX16S layout, with its switches, sliders and potentiometers in the same positions. It runs EdgeTX firmware, version 3.0.0 or higher, and controls up to 16 channels. The internal RF module is ExpressLRS with two LR1121 transceivers, operating on 2.4GHz and Sub-G 900MHz.
An STM32H7 processor runs the radio. The 5-inch IPS touchscreen has 800 x 480 resolution and adjusts its backlight automatically for reading indoors and out. Internal storage is 4GB of flash, and a MicroSD card slot takes a card (not included). Low-noise fans and an aluminum heat sink keep the radio cool.
The V6 Hall sensor gimbals run on quad bearings, with external adjustments for travel, centering and tension. Programmable RGB light rings around the gimbals are controlled through Lua and can be set as indicators for modes, warnings or status. The shoulder switch panels are removable, and the dual antennas fold for storage. It runs on two 3.7V 18650 cells, a 21700 5000mAh pack or a 2S 7.4V 6200mAh LiPo, none included.
It checks today's price at every store, compares the alternatives and answers in about a minute.




