The RXA-F2 is a 4-channel car audio amplifier rated at 2,400 watts peak and 600 watts Dyno Certified RMS. It uses a high-speed MOSFET power supply, studio-grade bipolar output stage transistors and ELNA audiophile capacitors. Its circuitry is Class A/B, with a design that simulates Class G by switching the rail voltage based on power use. Efficiency is about 65-70%.
It has a fully adjustable 12 dB/octave crossover with differential circuitry, a crossover band-pass control and a fully adjustable 12 dB bass equalizer. A 2 ch/4 ch input mode switch is included. High-level (speaker-level) inputs let you install it with a factory or aftermarket receiver that has no preamp outputs.
Auto-Start Smart turn-on senses a signal from the head unit and switches the amp on, so no remote turn-on wire is needed. Mute and delay soft start technology is built in. A fully IC-controlled protection circuit and peak limiter circuitry are included. Two 40 amp Maxi fuses protect the amp.
- Channels
- 4
- Peak power
- 2,400 W (2 x 1,200 W at 2 ohms, or 1 x 2,400 W at 4 ohms)
- RMS at 4 ohms
- 400 W (4 x 100 W) at 1% THD+N
- RMS at 2 ohms
- 600 W (4 x 150 W) at less than 1% THD
- RMS bridged
- 600 W (2 x 300 W) at 4 ohms, less than 1% THD
- Amplifier class
- A/B, simulated Class G
- Efficiency
- About 65-70%
- Crossover
- Fully adjustable 12 dB/octave, differential circuitry, band-pass control
- Bass EQ
- Fully adjustable 12 dB
- Inputs
- High-level (speaker-level) inputs; 2 ch/4 ch input mode switch
- Turn-on
- Auto-Start Smart turn-on
- Fuses
- 2 x 40 A Maxi fuses
- Power supply
- High-speed MOSFET
- Output stage
- Studio-grade bipolar transistors
- Capacitors
- ELNA audiophile brand
- Protection
- IC-controlled circuit, peak limiter, mute and delay soft start