
Sliding CrossCut Table
Best price now
Compared across 15 stores. Prices are checked against each store and labelled with when.

Compared across 15 stores. Prices are checked against each store and labelled with when.
The SawStop TSA-SA48 is a sliding crosscut table that bolts onto SawStop CNS, PCS and ICS table saws using pre-drilled mounting holes. Its 47-1/4-inch-deep table travels 55 inches for 48 inches of crosscut capacity, or 36 inches when flush-mounted to save shop space. The 43-inch aluminum fence extends to 58 inches and tilts to ±60 degrees with a single knob. It is a large, heavy accessory at 85 lb, and installing it requires cutting the saw's front and rear rails.
In stock
In stock
In stock
In stock
In stock
In stock
Availability unknown
Availability unknown
Availability unknown
Availability unknown
Availability unknown
Availability unknown
Availability unknown
Availability unknownSold by acmetools
Availability unknown
Availability unknown
Also available at
Store links may earn us a commission.
Lowest price we've seen: $1,485.00 on Oct 31 at Walmart. Tracked across 16 stores since Oct 31.
The Sliding Crosscut Table is a table saw accessory for compatible SawStop saws. It mounts through pre-drilled holes for SawStop saws. It is built for crosscuts, miter cuts, and detail cuts on half sheet material or smaller. The table depth is 47 1/4 in., and table travel is 55 in.
The table and fence are made from T-6 6061 aircraft-grade aluminum extrusions. Twelve bearings support the sliding action. The fence is 43 in. wide and extends to 58 in.
Crosscut capacity is 48 in., or 36 in. in a flush-mount setup. The miter gauge range is plus or minus 60 degrees.
It checks today's price at every store, compares the alternatives and answers in about a minute.















