
Small Screwdriver
Best price now
Prices are checked against each store and labelled with when.

Prices are checked against each store and labelled with when.
It checks today's price at every store, compares the alternatives and answers in about a minute.
A reproduction of William Ward's 1904 screwdriver patent, made in Canada from 1144 steel with solid cherry handle scales. The blade keeps a consistent width instead of the usual taper, and the tip is hollow-ground so 2.5mm stays parallel for full engagement with slotted screws. The square shaft accepts a wrench for extra torque, and the handle sits perpendicular to the blade for prying. It suits woodworkers, restorers and tool collectors who want a traditional slotted driver; modern drivers offer more sizes and Phillips or Torx tips, but few match this one's finish or its numbered, hand-finished build.
In stockShips from Canada · duties may applyReturn policy
This small screwdriver is made from 1144 steel. It is about 7.5 in / 19 cm long and weighs 0.23 lb / 105 g. Its design follows an 1904 patent by William Ward, with several modern improvements. It is entirely made in Canada.
The blade is 0.325 in / 0.825 cm wide and 0.05 in / 1.2 mm thick, hardened to 52 HRC. It holds a consistent width rather than the tapered shape common on modern screwdrivers, which helps when removing countersunk screws. The tip is hollow-ground, so 1/10 in / 2.5 mm of it runs parallel for engagement with the fastener.
The handle sits perpendicular to the blade, which adds strength when the screwdriver is used for prying. It is built to enclose the solid cherry handle scales so they stay in place. The square shaft can be gripped with a wrench to apply more torque to a stuck fastener. Each screwdriver is uniquely numbered under the handle scales.