
Stereo 2.1W Class D Audio Amplifier - TPA2012
Best price now
Prices are checked against each store and labelled with when.
Finding cheaper alternatives
Price facts
- Lowest price today: $12.73 at The Pi Hut (checked Nov 21, 2026).

Prices are checked against each store and labelled with when.
This is a tiny assembled breakout board built around the TPA2012 class D stereo amplifier chip. It delivers 2 x 2.1W into 4-ohm speakers at 10% THD and runs from 2.7V to 5.5V, so it suits battery-powered and portable builds. It is far more efficient than an LM386 amp and runs cool thanks to built-in thermal and over-current protection. The differential inputs, bridge-tied outputs and on-the-fly gain switch make it a flexible step up from basic op-amp boards, though it drives speakers directly and cannot feed another amplifier.
In stockShips from the UK · priced in GBP (£9.70) · duties may applyReturn policy
This incredibly small stereo amplifier is surprisingly powerful - able to deliver 2 x 2.1W channels into 4-ohm impedance speakers (@ 10% THD). Inside the miniature chip is a class D controller, able to run from 2.7V-5.5VDC. Since the amp is a class D, it's incredibly efficient (89% efficient when driving an 8Ω speaker at 1.5 watts) - making it perfect for portable and battery-powered projects. It has built-in thermal and over-current protection but we could barely tell it got hot. This board is a welcome upgrade to basic "LM386" amps!
The inputs of the amplifier go through 1.0uF capacitors, so they are fully 'differential' - if you don't have differential outputs, simply tie the R- and L- to the ground. The outputs are "Bridge Tied" - which means they connect directly to the outputs, with no connection to the ground. The output is a ~300KHz square wave PWM that is then 'averaged out' by the speaker coil - the high frequencies are not heard. All the above means that you can't connect the output to another amplifier, it should drive the speakers directly.
Comes with a fully assembled and tested breakout board with 1.0uF input capacitors. We also include a dual mini DIP switch for setting the amplifier gain on the fly, 3.5mm screw-terminal blocks so you can easily attach/detach your speakers, and some header in case you want to plug it into a breadboard . You will be ready to rock in 15 minutes! Speakers are NOT included , use any 4-ohm or 8-ohm impedance speakers.
• Output Power: 2.1W at 4Ω, 10% THD, 1.4W at 8Ω, 10% THD, with 5V Supply
• PSRR: 77 dB typ @ 217 Hz with 6 dB gain
• Designed for use without an output filter, when wires are kept at under 2"-4" long
• Four pin-selectable gains: 6dB, 12dB, 18dB and 24 dB. Select with the onboard switches or by setting the G0 and G1 breakout pins ( see schematic for breakout board showing gain pin settings for details )
• Excellent click-and-pop suppression
• Thermal shutdown protection
• Independent channel shutdown
• Low current draw: typ 6mA quiescent and 1.5uA in shutdown mode
Check out the tutorial for more details!
Note : The terminal blocks included with your product may be blue or black.
Revision History
As of August 1st, 2024 - We added a pre-soldered terminal block.
Specifications
• Dimensions (without 0.1" header): 22.96mm x 28.33mm x 4.97mm
• Weight: 2.56g
Resources
• Tutorial and Downloads
• TPA2012 Datasheet
It checks today's price at every store, compares the alternatives and answers in about a minute.




