Surron Light Bee (LBX) Rear Moto Brake Kit

Surron Light Bee Rear Moto Brake Kit — Ultra Bee brakes for the Light Bee

Want Ultra Bee stopping power on a Surron Light Bee X or Eride Pro? This rear moto brake kit puts a moto-spec Ultra Bee caliper and oversized rotor on your Light Bee, so the lever stays firm and the brake doesn't fade when you ride hard — balance point, trails or street.

What's included

• Single moto caliper bracket — billet aluminum, black anodized

• Surron Ultra Bee brake assembly: moto master cylinder, brake line, rear brake caliper

• 240mm × 3.3mm stainless steel brake rotor

Fits: Surron Light Bee X (LBX), Eride Pro S & SS, Ventus One, 79Bike Falcon

Why it works

• Moto-spec Ultra Bee rear caliper for instant bite and consistent feel — no spongy lever or fade

• 240mm rotor adds surface area and sheds heat for smooth, predictable braking and easier balance-point control

• Stainless coated rotor; aerospace 6061-T6 bracket; OEM Surron Ultra Bee assembly for an easy install

Install (summary)

• Remove rear axle, wheel and stock caliper bracket.

• Move the Ultra Bee caliper (with its rubber boot and pin) onto the moto caliper bracket.

• Install the rotor on the wheel; slide caliper + bracket over the rotor; reinstall the wheel and torque the axle.

• Run the brake line through the frame (pull the caliper-side banjo if needed for easier bleeding).

• Bolt the master cylinder to the bars and torque everything to spec.

• Bed the pads in slowly for at least 1 hour before hard/hot use — this is crucial.

FAQ

Does it fit the Surron Light Bee X? Yes — built for the Light Bee X (LBX) and Eride Pro S/SS.

Can I add a foot brake later? Not with this single-caliper kit — it carries one caliper. Use our dual-caliper kit to run a foot brake alongside the hand brake.

What rotor size? Made for our 240mm rotor. A 220mm rotor works only briefly if you must — and you must replace the pads when moving to 240mm so they bed correctly.

Ships from the USA.