The TOPPING DX1 II is a desktop DAC and headphone amplifier with a built-in DSP processor and preamp. It uses an ESS ES9039Q2M DAC chip and an XMOS XU316 USB processor. It supports PCM up to 384kHz and DSD256.
The headphone amplifier has a four-channel fully balanced design with independent left and right channels. The 4.4mm balanced output delivers up to 1000mW x2 at 32Ω. A 3.5mm TRRS jack supports gaming headsets with microphone input up to 24-bit/192kHz. The power supply is a patented low-noise discrete design, with a noise floor below 0.9μVrms.
The 10-band PEQ adjusts frequency, gain and bandwidth, with independent left and right channel tuning. Profiles are created in TOPPING Tune software. Optical input and output let the PEQ process audio from TVs, CD players, streamers and gaming consoles. RCA and 4.4mm line outputs connect to active speakers and power amplifiers. A single USB-C cable carries both audio and power, and an infrared remote controls volume and playback.
- DAC chip
- ESS ES9039Q2M
- USB processor
- XMOS XU316
- Supported formats
- PCM up to 384kHz, DSD256
- DSP
- 10-band PEQ with independent L/R channel tuning
- Software
- TOPPING Tune
- Headphone output
- 4.4mm balanced, up to 1000mW x2 @32Ω
- Headset jack
- 3.5mm TRRS, microphone input up to 24-bit/192kHz
- Line outputs
- RCA, 4.4mm
- Digital I/O
- Optical input and output
- Noise floor
- Below 0.9μVrms
- USB modes
- UAC 1.0 and UAC 2.0
- Compatibility
- PC, Mac, tablets, Nintendo Switch, PlayStation 5
- Power
- Via USB-C
- Remote
- Infrared remote control included