
Victron Energy Orion-Tr Smart Isolated DC-DC Charger (12/24/48V)
Best price now
Prices are checked against each store and labelled with when.

Prices are checked against each store and labelled with when.
The Orion-Tr Smart is an isolated DC-DC charger that turns an alternator or a source battery into a regulated multi-stage charger for a second battery bank. It delivers a true bulk, absorption and float charge with full galvanic isolation rated at 200 VDC between input, output and case, which removes ground loops and electrical noise. Setup is done over Bluetooth, and it works with both lead-acid and lithium banks. It suits boats and vehicles with long alternator runs or mixed-grounding systems; the non-isolated Orion-Tr Smart is the lighter, cheaper pick when a common negative is fine.
In stockReturn policy
The Orion-Tr Smart is an isolated DC-DC charger that turns an engine alternator or a source battery into a multi-stage charger for a second battery bank. It takes a variable input voltage and delivers a regulated charge to the service battery while protecting the battery it draws from. It works with lead-acid and lithium banks.
The unit provides full galvanic isolation of 200 VDC between input, output and case, so the source and destination battery grounds are electrically separated. That eliminates ground loops, reduces electrical noise, and suits installations where the input and output negatives cannot be common. Charging follows a bulk, absorption and float algorithm: absorption shortens after shallow discharges and extends after deep ones on lead-acid banks, while lithium uses a fixed absorption time of 2 hours by default. Profiles can be configured to a battery maker's specification, or the output can be set to a fixed voltage so the unit runs as a stabilized DC power supply.
Engine-running detection starts charging only when the engine is running and stops when it is not, so the starter battery is not drained at rest; this covers ECU-controlled alternators that can drop below the voltage a service battery needs. Built-in Bluetooth lets you monitor and configure the charger, including charge state, input and output voltage, warnings and alarms, from the VictronConnect app. A remote on/off input accepts an ignition signal, BMS contact or switch. Connections are screw terminals taking up to 16 mm² / AWG 6, and any number of units can be paralleled to increase output current.
It checks today's price at every store, compares the alternatives and answers in about a minute.












