It checks today's price at every store, compares the alternatives and answers in about a minute.
A round 1.85-inch 360×360 touchscreen dev board built around the ESP32-S3R8, with 8MB PSRAM and 16MB flash. This BOX version adds a speaker enclosure, dual microphones, an ES8311/ES7210 audio path and a 1,000 mAh battery, so it runs untethered. It suits makers building voice-controlled smart speaker interfaces, AI speech terminals and portable round-display projects. Against bare ESP32-S3 display boards it trades expansion pins for a finished audio-and-battery package; against consumer smart speakers it gives full firmware control but no ready-made assistant.
In stockShips from abroad · priced in EUR (€44.85) · duties may applyReturn policy
A small set of owners rate it highly, praising the sharp round display and the convenience of built-in audio and battery for ESP32-S3 projects.
The ESP32-S3-Touch-LCD-1.85C-BOX is a round touchscreen display board with a built-in speaker box and a 3.7V lithium battery. Its 1.85-inch LCD has a 360×360 resolution and shows 262K colors. The display uses QSPI, and the capacitive touch panel connects over I2C with interrupt support.
An ESP32-S3R8 provides an Xtensa 32-bit LX7 dual-core processor running at up to 240 MHz, with 512KB SRAM, 384KB ROM, 8MB PSRAM, and 16MB Flash. It connects over 2.4 GHz Wi-Fi (802.11 b/g/n) and Bluetooth 5 LE. Audio hardware includes dual microphones, a speaker box, an ES8311 audio decoder, and an ES7210 audio encoder.
The board also carries a PCF85063 RTC, a TF card slot, and an MX1.25 battery header for the included 1,000 mAh battery. A 28-pin 1.27 mm header and UART, I2C, and RTC battery connections are available for expansion. An IPEX1 connector lets an external antenna be enabled by resistor rework. It is intended for voice interaction, smart speaker style interfaces, and portable touchscreen projects.














