A standalone sound-effects trigger board that plays WAV or OGG files from 16MB of onboard flash when a button or sensor closes a contact. No Arduino or programming is needed: load files over USB, wire a trigger and a speaker, and it plays. The built-in 2x2W class D stereo amp drives speakers directly, so it suits props, costumes and small installations where a microcontroller setup is overkill. Against MP3 shield and Wave Shield builds it trades flexibility for simplicity, and against ISD chips and greeting-card recorders it sounds far better.
In stockShips from the UK · priced in GBP (£22.67) · duties may applyReturn policy
Makers who use it praise how quickly a sound effect can be added to a prop with no code. Complaints center on the fixed amp output and the limited 16MB of storage.
The Adafruit Audio FX Sound Board is a stand-alone audio trigger board with a built-in 2 x 2W stereo Class D amplifier. It plays WAV or Ogg Vorbis files from 16MB of onboard storage and needs a 3 to 5.5 VDC battery. No Arduino or other microcontroller is required.
Audio files are loaded over micro USB through built-in mass storage, so the board appears as a USB drive for file transfer. The decoding hardware supports mono or stereo and any bit/sample rate, including 44.1 kHz 16-bit stereo. Up to 11 buttons or switches can be connected to trigger audio files.
Each trigger plays files according to the file name, with five trigger effects: Basic, Hold Looping, Latching Loop, Play Next, and Play Random. A stereo line out is available for headphones, and the built-in amplifier connects directly to 4-8 ohm speakers. The board is not polyphonic, does not play MP3 files, and is not reprogrammable or scriptable.
It checks today's price at every store, compares the alternatives and answers in about a minute.